The OPEN.ioting device is suitable for feedback of the open and closed status of the gate. This way you can verify the position of the gate before starting the control.

This function is also suitable for checking the status of the gate (whether it is open or closed) and whether the garden or garage gate has closed without obstacles.

The IN1 and IN2 inputs are used to connect the limit switches.

• The limit switch indicating the fully open state of the gate must be connected to the IN1 input.
• The limit switch indicating the fully closed state of the gate must be connected to the IN2 input.
• The device automatically detects the change in state of the connected limit switch and manages the limit positions based on that.

So, if you do not want to use a limit switch, do not connect the IN1 and IN2 inputs.

The device can also handle one or two limit switches.

If the limit switches connected to inputs IN1 and IN2 are normally closed (NC) , i.e. they provide an open dry contact when the gate is fully open or fully closed, then set switch S1 to the upper “ON” position.

If the limit switches connected to inputs IN1 and IN2 are normally open (NO) , i.e. they provide a closed dry contact when the gate is fully open or fully closed, then set switch S1 to the lower “OFF” position.

The device automatically detects the IN1 and IN2 limit switches! If the limit switches are connected, the mobile application displays the open, closed and intermediate states of the gate (if IN1 and IN2 are also connected) - that is, when the gate is opening or closing:

Read the frequently asked questions below. In our experience, you will find a solution to 95% of the problems, but if not, our Technical Support colleagues are always at your disposal.